Spartanics
Rolling Meadows, IL 60008
Jul 02, 2008 Featuring flat or vertical design, Sheet and Web Contact Drying System thoroughly dries wet inks from material surface to top side, avoiding residual moisture problems. System uses heated vacuum plate with transport belt on bottom of material being dried. Integrated heated air blower furthers drying process and helps eliminate solvent fumes. With system, screen printed materials that previously required 2 hours to dry can be dried within 30 seconds.

Radio Frequency Co., Inc.
Millis, MA 02054
Jul 01, 2008 Designed for high-speed drying of water-based patterned glue and coatings, Macrowave(TM) RF Drying System selectively heats only patterned coatings on web and leaves bound moisture in substrate intact, preventing over-drying, distortion, and shrinking. It needs 1/3 to 1/5 of floor space required for hot air and IR dryers, and permits lower web temperatures. Unit can handle webs up to 120° wide and meets OSHA safety regulations and FCC standards on communication non-interference.

MEGTEC Systems
De Pere, WI 54115-5030
Jul 01, 2008 Developed for 80-page presses with web width up to 2,400 mm, DLC 6000 Match-Speed Splicer can handle 60 in. diameter rolls at max production speed of 3,540 fpm. Rolls load into paster by automatic roll-handling systems that have adjustable automation level, allowing roll changing without operator. Additional features include split-arms that minimize changeover time when changing web width, integrated infeed unit with 290 daN max web tension, and quick-change 3 and 6 in. chucks.

MEGTEC Systems
De Pere, WI 54115-5030
Jul 01, 2008 With splice efficiency rating over 99.5%, MP Series carries newspaper rolls from 40-67 in. wide with roll diameter of 50 in. Rolls can be loaded manually or automatically direct from floor level. Fully automatic chucks are positively locked into core and do not have to be re-tightened during running. Adjustable up to 67 in., split arm permits loading of 2 rolls with different widths. Single and double width models are available with 2- or 4-quadrant drive capability.

MEGTEC Systems
De Pere, WI 54115-5030
Jun 30, 2008 Roll-Blade RQS incorporates optimized web-air-transport system, Airstream II, which optimizes performance levels while minimizing energy consumption and noise. Available with speeds to 50,000 and 60,000 cp/h, sheeter enables important process parameters to be adjusted centrally during production. Papers of different quality can be used without problems, and Web Snap system avoids paper wraps at low paper weights.

Gerber Scientific Products, Inc.
South Windsor, CT 06074
Jun 24, 2008 With programmable machine settings, GERBERcutter® Z7 multi-ply cutter helps maximize throughput and yield while cutting intricate shapes, multiple hole sizes, and notches. It is suited for full range of material types and thicknesses, including bi-laminate foams, technical textiles, and high-loft fabrics. Product targets automotive, aerospace, and technical textiles markets.

Spectro Coating
Leominster, MA 01453
Jun 19, 2008 With nanotechnology finishing that withstands 150,000 double rubs, Primo 150 Upholstery Fabrics are suited for manufacturers of commercial, hospitality, and residential furniture and automotive, RV, and marine interiors as well as gaming surfaces. Textured fabrics can be cleaned using mild soap and warm water. Available in 55 in. rolls, upholstery fabrics are made using environmentally friendly water-based and low VOC chemicals.

PermaFlex Engineering
Orange, MA 01364
Mar 18, 2008 Configured vertically or horizontally, AccuNip® Nip Stations with aluminum frames offer nip loads up to 2,000 lb, while cast iron and steel frame units produce up to 25,000 lb of nip load. Stations can be customized with doctor blades, dual-roll gear drives, heating or cooling rolls, and adjustable nip pressures and gaps. Light- and medium-duty models are suited for laminating, thermal bonding, web heating/cooling, and web pulling or squeezing.

Milliken & Co.
Spartanburg, SC 29304
Feb 26, 2008 Designed for industrial workwear, Amplitude(TM) is constructed of cotton/nylon blend designed to help mitigate potential injuries due to electric arc and flash fire exposure. This flame resistant fabric is processed ammonia-free and promotes freedom of movement through stretch. It offers Hazard Risk Category 2 electric arc protection for NFPA 70E, ASTM F1506, and OSHA 1910.269 compliance as well as flash fire NFPA 2112.

Spectro Coating
Leominster, MA 01453
Jan 18, 2008 Eliminating need for separate hanging panels and hardware, Spectro Two-in-One(TM) Drapery Fabric features one panel with fabric on front and blackout on back. Sunlight, temperature, and noise insulating drapery can be produced to coordinate with any interior design theme. Meeting NFPA 701 (2004), 100% blackout window treatment is suited for architects, interior designers, and converters and distributors of hospitality fabrics, motorhome interiors, and yacht builders.

DuPont Co., Packaging & Industrial Polymers
Wilmington, DE 19898
Oct 22, 2007 Featuring inherent flame resistance that will not diminish through laundering, bleaching, or wear, DuPont(TM) Protera(TM) fabrics are engineered to protect against electric arc hazards. They meet NFPA 70E Category 2 and National Electrical Safety Code (NESC) requirements while promoting comfort for electricians in industrial segments as well as utility workers. Garments made with this material do not require special laundry processing.

Wacker Chemical Corp.
Adrian, MI 49221
Oct 03, 2007 Imparting silky-velvety hand, WETSOFT® NE 580 silicone softener emulsion is designed for hydrophilic finishing of textiles. Self-dispersing microemulsion concentrate imparts absorbency and stability in alkaline solutions. Used on its own or together with other finishing agents, it is suited for use in finishing natural, mixed, and synthetic fibers. Solution remains stable when exposed to high pH values, elevated temperatures, high shear, and salts.

Diolen Industrial Fibers
ARNHEM 6800 TC  Netherlands
Sep 17, 2007 Made with Fortron® polyphenylene sulfide, high-tenacity Diofort® is inherently flame-retardant and chemical resistant. It can be combined with glass, carbon, and other polymer fibers to yield blended fabrics. In addition to reinforcing hydraulic oil hoses in power steering systems where it reduces noise and vibration, product can be applied in fuel lines and charge-air coolers to provide resistance to high pressure and temperature while allowing flexibility.

Kimberly-Clark Professional
Roswell, GA 30076
Aug 02, 2007 WypAll Microfiber Cloths feature Microban Antimicrobial Product Protection that removes bacteria from non-porous surfaces and helps prevent cross-contamination between surfaces. When bacteria come in contact with cloth, Microban penetrates cell wall of bacteria making it unable to function, grow, and reproduce. Thick, heavy, durable, and absorbent cloths hold up to 8x their weight in liquid and prevent bacterial growth even after repeated laundering.

Gerber Technology, Inc.
Tolland, CT 06084
Aug 01, 2007 GERBERspreader XLs125 ensures material rolls weighing up to 160 lb are spread without tension and that edges are perfectly aligned. Capable of spreading woven or knit materials in roll or flat form for variety of applications, machine enables parts to be nested closer to beginning, end, and edges of spread. Windows®-based, icon-driven interface facilitates operation, while fabric roll cradle feed system tilts automatically to facilitate loading and unloading.

Nim-Cor, Inc.
Nashua, NH 03061
Jul 30, 2007 Targeting web-process industry, Roll Restorer utilizes hydraulic pressure to reform damaged cores from 2-12 in. ID. Mobile cart provides storage and mobility while carrying all expander heads and flanges for different core sizes. With Roll Restorer, operators can salvage good product and avoid lost productivity when damaged cores prevent conventional unwind mounting.

Honeywell International, Inc.
Morristown, NJ 07960-4648
Jun 28, 2007 Transparent to radar, Spectra Shield® II fiber-based material is made from ultra-high molecular weight polyethylene using gel-spinning process. It exhibits resistance to chemicals, waters, and UV light as well as vibration damping, flex fatigue, and internal fiber-friction characteristics. Material is used for ballistic protection and security applications, from bullet-resistant vests, breastplates, and helmets to combat vehicles and military aircraft.

Andantex USA, Inc.
Wanamasa, NJ 07712
Apr 24, 2007 Digital controller, Merobel DGT300, provides regulation capabilities for printing, labeling, and converting machinery. Employing Windows-based software, unit contains programming options such as inertia compensation, taper adjustment, on-the-fly management of web turrets, and E-stop torque control in proportion to set point. Solution, operable in closed- as well as open-loop modes, contains 5 built-in memories and one integral power supply.

Breach Security, Inc.
Carlsbad, CA 92011
Dec 01, 2006 Incorporating ModSecurity(TM) v2.0 open source web application firewall, ModSecurity Pro(TM) M1000 appliance includes rule sets for compliance with Payment Card Industry v1.1, as well as protection for Microsoft(TM) Outlook Web Access (OWA). Hardened appliance is built with secure configurations of OS and Apache web server, and uses SSL encryption module to provide network encryption. It also has capability to run antivirus applications to scan uploaded files.

DuPont
Research Triangle Park, NC 27709-4425
Nov 15, 2006 Engineered to meet NFPA 70E Category 2 requirements, DuPont(TM) Protera(TM) Fabrics provide more comfort and longer lifecycle than FR cotton nylon blends. Inherent flame resistance will not diminish through laundering or bleaching and will not require special laundry processing. Available in fabric weights of 6.5 and 8.0 oz/sq-yd, Protera fabrics come in medium blue, khaki, and navy blue colors.