Supertex Inc.
Sunnyvale, CA 94619
Jul 03, 2008 Suited for use in Class-D audio amplifiers, Model MD7120 provides 12-200 V output, ±5 nanosec dead time matching, and rise or fall time of less than 30 nsec with typical 1 nF load. Unit can be connected directly to 200 V supply voltage to drive over 100 W output with 90% efficiency. Its internal core consists of control logic, level translators, bootstrap-powered high side gate driver, and over-temperature, under-voltage, and current protection circuits.

Electro Standards Laboratories
Cranston, RI 02921 3403
Jul 03, 2008 Offering manual control via front panel pushbuttons or remote control from RS232 serial port, Model 7348 Tri-Channel RJ45 Cat5 A/B switch connects 1 device between 2 other devices or networks. Each channel of rackmount unit is individual switch that is independently controlled, maintaining last set position even in event of power loss, while continuing to pass data. Remote ASCII commands can lockout front panel controls and allow each channel to be switched individually or all simultaneously.

STMicroelectronics
GENEVA   Switzerland
Jul 03, 2008 Including 10-, 12-, and 16 MHz devices, STCL1120 family of oscillators have fixed operating frequency that is accurate to within ±1.5% in all operating conditions, and operating temperature from -20 to +85°C. Push-pull, CMOS-compatible output produces square wave for direct interfacing with on-board components. By implementing external chip-select pin, engineers can stop clock when application is in standby mode, gaining power savings by reducing oscillator current to less than 3 µA.

Anadigics, Inc.
Warren, NJ 07059
Jul 03, 2008 Operating in 5-85 MHz frequency range, Model ARA2017 supports DOCSIS 3.0-specified signal levels of +64 dBmV while minimizing harmonic distortion and output noise levels. Linear amplifier features 33 dB of RF gain at minimum attenuation, and includes digitally controlled, multi-stage precision step attenuator that provides up to 58 dB of attenuation in 2 dB increments. Requiring single 5 V supply, device is offered in 28-pin 5 x 5 x 1 mm QFN package.

RF Micro Devices, Inc.
Greensboro, NC 27409-9421
Jul 03, 2008 Suited for use as power doubler amplifiers in line amplification and HFC optical nodes, Models D10040200PH1 and D10040230PH1 feature 20 and 23 dB of gain, respectively. Available in industry-standard SOT115J module package, both utilize ultra-linear, high-efficiency GaN process technology, and feature +24 Vdc supply voltage and maximum CTB of -74 dBc and CSO of -68 dBc. Model D10040200PH1 has CIN of 65 dB minimum, while D10040230PH1 has 63 dB minimum.

Fox Electronics
Fort Myers, FL 33905 5022
Jul 02, 2008 Suited for communication, data transfer, test and measurement equipment, F53 Series comes with stability options of 15 ppm (F537), 10 ppm (F539), and 8 ppm (F53S), and temperature range of -20 to +70°C or optional temperature range of -40 to +85°C (R Version). Series has input current (IDD) of 7 mA and output current (IOL) of 4 mA min, output symmetry of 45-55% over frequency range of 4-54 MHz, phase noise of -140 BC/Hz at 10 kHz offset, and jitter period of 3 ps (rms).

Vectron International
Hudson, NH 03051
Jul 02, 2008 Available in frequencies ranging from 10-30 MHz, Model EX-620 Evacuated Miniature Crystal Oscillator (EMXO) features ruggedized hybrid thick film construction in low profile hermetically sealed 4-pin HALF DIP package which can withstand severe environmental conditions. OCXO offers ±75 x 10^-9 temperature stability over -20 to +70°C range, and consumes less than 0.35 W at 25°C and 0.7 W at -40°C. Available in thru-hole and surface mount package, it weighs less than 3 g.

Nokia Siemens Networks
Espoo 02610  Finland
Jul 02, 2008 With multi-service and multi-reach feature set, hiT 7300 supports all reaches and transmission speeds in metro, regional, long-haul, and ultra-long haul applications on single platform. Unit has transponder cards that support traditional SONET/SDH, Ethernet, and SAN services at different speeds. Including amplifier options and end-to-end management support for all equipment configurations, it is also available in flatpack form factor suitable as CPE for tight space requirements.

ARRIS
Suwanee,, GA 30024
Jul 02, 2008 ARRIS optical passives are ergonomically designed in OM4100 node fiber tray and field splice enclosure packages within 1 GHz CHP CORWave system, and allow for plug/play features in multiple wavelength systems. Facilitating quick segmentation which eliminate need for fiber construction, units can be installed without specialized equipment, fusion splices, or complex fiber routings in field. They offer high isolation and low insertion loss over operating temperature range.

Opto Diode Corp.
Newbury Park, CA 91320
Jul 01, 2008 Hermetically sealed in TO-39 can for integration into new or existing systems, 5 mm² Model ODA-5WB-100K offers wavelength response of 28 V/mW at 450 nm, responsivity range from 400-1,100 nm, and peak spectral response of 940 nm. Blue/green-enhanced device features storage and operating temperatures from -25 to +100°C, and is suited for industrial and biomedical applications, such as fluorescence and phosphorescence.

Aeroflex Laboratories
Plainview, NY 11803
Jul 01, 2008 With frequency range of 1 MHz to 3 GHz, Model 3020C PXI has wideband width modulation up to 90 MHz for broadband communications standards or multi-carrier test applications as well as RF output power from -120 to +6 dBm. It incorporates dual-channel arbitrary waveform generator for supplying complex modulated signals, and is supplied with 0.5 GB of memory supporting up to 128 M x 16 bit I and Q samples. The 3020C can perform high-speed switching in less than 250 µs when in list mode.

Tyco Electronics Corp.
Harrisburg, PA 17105-3608
Jul 01, 2008 Supplied in 2 x 2.5 mm, PQFN plastic package, MAAP-008516 is RoHS-compliant, 3-stage, 2.4-2.5 GHz linear power amplifier with typical linear gain of 30 dB at operating voltage of 3.3 V. Integrated power detector promotes accurate power control, while separate power mode pin lends to current savings in power shutdown mode. Respectively, unit generates 16.5 and 21.5 dBm linear output power for 802.11g and 802.11b applications while drawing 80 and 95 mA current.

Precision Resistor Co., Inc.
Largo, FL 33777-1421
Jul 01, 2008 Model PVS5 current sensing, surface-mount, wire-wound 5 W electrical shunt is able to dissipate ambient heat associated with reflow ovens. It is manufactured with epoxy resin ratio mixture that can withstand temperatures seen in most standard reflow ovens and which ensures parts do not drift out of close tolerances.

u-blox AG
Schweiz   Switzerland
Jul 01, 2008 Available in 12 x 16 x 2.4 mm package, NEO-5Q features ROM-based architecture, eliminating need for external Flash EPROM. With acquisition performance of 1 sec, it has 50-channel positioning engine and over 1 mil correlators capable of simultaneously tracking GPS/GALILEO signals. KickStart weak signal acquisition technology ensures fast positioning regardless of signal positions and antenna size, while SPI enables external serial E2PROM to store unlimited start-up configuration settings.

Atmel Corp.
San Jose, CA 95131
Jul 01, 2008 Compatible with 5 V input supply, AT73C237 Power Management Unit (PMU) generates 4 regulated output voltages with programmable output voltage selection and output current up to 70 mA. Three LDO regulators provide programmable voltage from 1.2-2.75 V required by RF and analog devices, while one 1.8 V regulator is for backup battery/capacitor recharging. Integrated 2-wire interface allows any MCU to program variable LDO output voltages and manage the enable of each LDO.

Keithley Instruments, Inc.
Cleveland, OH 44139 1891
Jun 30, 2008 Featuring signal library for SISO and MIMO wireless standards, SignalMeister(TM) v2.0 uses click-and-drag, objects-based approach to facilitate creation of basic and complex waveforms. It enables creation of entire range of signals in accordance with WiMAX/WLAN wireless connectivity standards and 3GPP/3GPP2 cellular standards. With this PC-based RF development tool, users can create waveforms from multiple signal standards with optional additive impairments and channel modeling.

Sullins Electronics Corp.
San Marcos, CA 92079-0189
Jun 30, 2008 Offered in plated through hole and SMT versions, male and female 0.050 in. headers are available with one or 2 rows of up to 50 contacts each. RoHS-compliant products, ordered with straight or right-angle dip-solder terminations, are also available in specifiable pin lengths and insulator height options. While female versions are supplied with high-temperature liquid crystal polymer insulators, male parts feature Nylon 9T insulators. Both have current rating of 1 A per contact.

Z-Communications, Inc.
San Diego, CA 92126
Jun 30, 2008 VCO model CLV1370A-LF in L-band operates from 1,360-1,380 MHz with tuning voltage range of 0.5-4.5 Vdc. It is designed to operate at 5 Vdc, drawing 18 mA typical over -40º to +85ºC temperature range. Typical 2nd harmonic suppression is -20 dBc. RoHS-compliant device comes in standard MINI package measuring 0.50 x 0.50 x 0.22 mm and is available in tape and reel packaging for production requirements. It is also suited for automated surface mount assembly and reflow.

TT electronics IRC Wirewound and Film Technologies Division
Boone, NC 28607
Jun 30, 2008 HVC Series thick film resistors feature high voltage operation in 1206, 2010, and 2512 package sizes, with power ratings of 0.3, 0.5, and 1 W and rated voltages of 1,000, 2,000, and 3,000 V, respectively. They have 100 kW to 1 MW resistance range, with tolerances to 0.5%, 1%, 2%, and 5%, maximum overload voltage to 4.5 kV, and -55 to +155°C operating temperature range. Units offer less than -25 ppm voltage coefficient and ±100 ppm/°C temperature coefficient.

Vectron International
Hudson, NH 03051
Jun 30, 2008 Utilizing high stiffness micromechanical resonator, Model VMEM5Q is available from 1-130 MHz with 100 ppm and 50 ppm stabilities and temperature range of -40 to 85°C. Oscillator operates off 3.3 V supply and has enable/disable feature to allow clock output to be disabled for board testing. Housed in 5 x 3.2 mm QFN package, device meets MIL-PRF-55310 standard and is suited for manufactures of smart munitions, projectile electronics, and missiles.